I should have done pictures of before and after with each seat off the car for comparison but got too lazy for that.
Its a lot of work but its relatively easy.
Keep in mind this was my first shot at it and the close up of the seat is for a section that was quite bad and i applied a bit of filler which looked bad (first attempt)
I did the same on the other seat bolster and it looked good, so its a matter of practice.
The kit included leather prep which is a solvent, alcohol, paint, sealant and an airbrush to apply everything.
The paint is almost idiot proof and it looks great.
My problem is with the sealant that is too liquid and i tend to put too much and end up with a white residue on the seats.
Dont know if it will come off as i can only clean it 1 week after the sealant is applied.
In the places that the leather was just stained, faded or creased it looks like new.
Where filler was applied, it variates in quality, the worst one being what is on the close up (first one i did) and the best one being the drivers side bolster that looked quite good considering the previous state where bits of leather were already missing (last ine i did)