RodTungsten
Member
- Messages
- 589
On one side the screw latch will often not be fully released on opening - closes down just fine. I have stripped, cleaned and re-greased the locking motor gearbox and even with Matt’s recent greasing it usually takes a couple of open/close cycles to release the screw from the latch.
That side does not seem to pull down excessively so adjusting the stop micro switch may not help.
Does anyone know if the screw unwind time is modifiable in the capote control ECU?
That side does not seem to pull down excessively so adjusting the stop micro switch may not help.
Does anyone know if the screw unwind time is modifiable in the capote control ECU?